Modern LED technology
Discrete (DIP) versus SMD LEDs
The way the LEDs are packaged determines almost everything about a screen: how sharp, how bright, how wide the viewing angle. The major divide is between the older discrete (DIP) LED and the modern SMD LED.
The oldest large screens used separate lamps: a separate red, a separate green and a separate blue lamp, each with its own legs. These are very bright and last a long time, perfect for large signs you view from a distance.
Newer screens put those three colours together in one very small block: an SMD LED. As a result the dots fit closer together, the image looks sharper and you can also see it well from the side.
A discrete or DIP LED (Dual In-line Package) has its own housing per colour, with legs that are pushed through the circuit board and soldered. DIP LEDs are very bright and mechanically robust (resistant to vibration), but because of their size they are limited to larger pixel pitches (typically P10 and larger). They are used mainly for large outdoor signs.
SMD: the current standard
In an SMD LED (Surface-Mount Device), the red, green and blue chips sit together in one small package that is soldered onto the surface of the board. That allows much denser placement (pitches from about 1.2 mm), a higher resolution, a wider viewing angle (up to about 160°) and a more uniform colour image. SMD has for years been the standard for most indoor and modern outdoor screens.
When to use which
Rule of thumb: DIP for very large, bright signs at long viewing distance; SMD for sharper images, wider viewing angles and smaller pitches. Below about 1.0 mm pitch, SMD runs into limits; there, COB and IMD take over.
The core difference is through-hole (DIP) versus surface-mount (SMD) mounting. DIP offers high on-axis brightness and mechanical robustness, but the construction limits pixel density and gives a narrower, strongly directional viewing angle. SMD integrates R/G/B in a single package, which delivers finer pitch, wider viewing angles and better colour uniformity.
Pitch limits and successors
SMD dominates from indoor fine-pitch to outdoor. As the pitch drops below ~P1.0, SMD yield and robustness run into limits: the package becomes too large and fragile. There, COB (chips directly on the board, encapsulated) and IMD (several pixels in one package) appear. For outdoor contrast, SMD is moreover made in a black housing; see white vs black LED.